Pool hydraulics at estate scale
A 30 m lap pool and a 10 m waterfall have very different flow demands, and the waterfall's infinity-edge trough and collection system has to stay in balance with the main pool.
Rather than teeing several circuits into a shared header, each of the roughly 10 suction and return points runs on its own line into the manifold. Flow can be set circuit by circuit, any one line can be isolated without disturbing the rest, and a fault traces back to a single pipe.
A fully cross-coupled manifold
The core of the plant room is a fully cross-coupled manifold, built in-house from white PVC, with a 3-way diverter valve at every major junction. Any pump can drive either filter and either chlorinator.
Any pump can also feed the waterfall, feed the floor jets, draw from the trough, draw from the pool, or return to any of them, in combination or in sequence. Multi-mode selection valves change the setup with a turn of a handle instead of cutting and re-plumbing pipe.
How the pumps run
The Neptune 2 HP DC variable-speed pump drives the main 28-inch filter. It can draw from the trough or the pool, but primarily draws from the pool's main drain and returns through the waterfall feeds and the pool returns.
In standard operation the Astral BX 2.0 HP runs as a high-flow circulation pump, pushing water fast to floor jets set about 15 mm off the pool floor. Along the 30 m lap pool, the jets sweep debris toward the infinity-edge end, where it flows over into the trough.
The Neptune 1.5 HP DC variable-speed pump completes the cross-coupled set of three.
Waterfall and infinity-edge plumbing
The 10 m waterfall falls into an infinity-edge trough and collection system. Water collected in the trough runs through a dedicated 25-inch fibreglass filter with a leaf canister.
That trough loop also carries chlorinated water and sends it straight back up to the top, to the waterfall and the pool, so the collection side never sits as a dead end.
Two chlorinators, one system
The plant room runs two chlorinators. The Lincoln chlorinator already on site was in good working order, so it was retained and reused: we don't throw out sound equipment. Alongside it is a PoolPro ultra low salt chlorinator (1500 ppm) with an accompanying magnesium mineral doser.
Both chlorinators can serve the pool and the trough and waterfall water, together or separately depending on load.
Non-return valves and fault tolerance
The pool sits well above the plant room, so every pump works against a 50 m static head. Every line carries a non-return (check) valve, so whichever system fails or interacts with another, there is no direct overflow risk and no siphon effect. Siphoning is a common failure in infinity pools without properly designed plumbing.
The system is designed to keep running with more than one component out of service at the same time. Any pump, filter or chlorinator can be isolated for maintenance while the rest keep the pool and waterfall running, and the controllers have manual override so circulation and water quality hold while part of the automation is serviced.