New gear needs to work with what you already have. We check the pipes, flow, and space before we install anything.
What we do
Installation of pumps, filters, chlorinators, and heaters
Before we arrive
Send photos of the old gear, the pipes, and the space around it.
Replacing broken or old equipment
Upgrading to an automated system
Adding a heater to the pool
Fixing a messy equipment area
Making the gear quieter
Setting up a brand new pool system
Pool size and water flow needs
Pipe sizes and valve setup
Filter and heater flow limits
Power supply and power points
Space, drainage, and ventilation
Room to reach the gear for servicing
Pool equipment we work on
We check the equipment, water path and controls before we recommend a repair.
Common problems
The same problem can have a few different causes. We test before we start replacing gear.
What might cause it
The existing pipework, filter, valves or pump settings may not provide the flow the new unit requires
How we check
We establish the system pressure and flow, trace the full water path and confirm the new equipment's operating requirements before altering settings or pipework
What might cause it
A seal may be pinched, a joint may be poorly prepared, or unsupported and misaligned pipework may be loading the connection
How we check
We inspect the alignment and supports, then pressure test every new section and union under the conditions it will actually run
What might cause it
The layout has insufficient service clearance or the components were installed in the wrong sequence
How we check
Before final connection, we physically check lid removal, valve operation, electrical access and the space needed to replace each serviceable part
Our process
We work out the flow, heating, and cleaning needs.
We look at the space, power, and pipes.
We install the gear straight, with room to service it later.
We turn it on, test it, and show you how it works.
After the visit
We fit the new unit and match it to the old pipes.
We replace the gear and tidy up the messy plumbing.
We fit the urgent parts now and leave room for the rest later.
Questions
Straight answers to the questions we hear most often.
Yes, if it is still made and it was the right size to begin with. We always check the sizing first.
Usually a little bit. New gear has different connections, and we want to make sure it does not leak.
We look at the pool volume, the pipe size, and what the heater and cleaner need to work.
We tell you exactly what power is needed so your electrician can hook it up.
Yes. We take the rubbish and the old parts with us.
Book pool equipment installation melbourne
Send us your address, a few photos, and a quick description. We will come prepared with a clear idea of where to start.
Shop 13A, 328 Johnston Street, Abbotsford VIC 3067
9am to 6pm, Monday to Friday. Saturday by appointment.
Check service areas