Skip to main content
A pool heat pump installed beside a filter against a brick wall, plumbed into the circulation line

Heat sources that work together

Heating Integration: Heat Pump, Gas & Solar Plumbing

A heater is only as good as the water going through it. Too little flow and it trips, too much and you waste head for nothing, and in the wrong order the heat sources work against each other. Heating integration is mostly a plumbing job.

Flow in range

Each heater gets the flow its maker asks for, with a bypass where needed.

Right order

Solar first, then heat pump or gas, with the chlorinator last.

Controls that agree

One logic deciding which heat source runs, and when.

Correct order, bypasses and flow so each heat source does its job.

Plumbing for heat

01

Each heater has a flow window

Heat pumps and gas heaters each need flow within a range. Below it, flow switches trip or the unit overheats. Above it, the exchanger adds unnecessary head. A bypass with a balancing valve keeps the heater in its window while the rest of the system runs at its own flow.

02

Order of heat sources

Where solar is combined with a heat pump or gas, solar usually goes first. It does its best work on the coolest water, and the other heater tops up only what's left.

03

Chlorinator after the heat

Strongly chlorinated water straight from the cell is hard on heat exchangers. The chlorinator sits after heating, last before the returns.

04

Solar adds static head

Roof-mounted collectors can add several metres of lift. Solar circuits need a pump sized for that height, a non-return valve, and a vacuum release or air bleed at the top so the panels drain and don't hold a vacuum.

Heat pumps in Melbourne conditions

A heat pump's output falls as the air gets colder, and in Melbourne's cooler months it will defrost more often. Placement matters as much as size: it needs free airflow so it isn't breathing its own cold exhaust, a level, drained base, and a position that respects EPA Victoria's night-time limits for heat pumps that can be heard inside a neighbour's habitable room.

Gas, flues and licensed work

Gas heaters need flue clearances and a licensed gas fitter for connection. We handle the water side, the bypass, isolation and flow, and coordinate the gas and electrical work with licensed trades.

Pool and spa on one heater

When a spa and pool share a heater, valve sequencing decides where the heat goes. The spa needs fast heating at a lower flow. The pool needs gentle heating across a much larger volume. We set up the diverters and controls for both.

A heat pump beside an existing pool heater against a brick wall
A heat pump beside an existing pool heater against a brick wall.

What we measure and specify

  • Manufacturer flow range for each heater
  • Bypass and balancing valve sizing
  • Order: solar, then heat pump or gas, then sanitiser
  • Static head to roof collectors
  • Airflow and drainage around heat pumps
  • Spa and pool heating modes sequenced

What you get

No nuisance trips

Heaters fed with the flow they need, in every mode.

Lower heating cost

Cheapest heat used first, topped up only as needed.

Clear control logic

One set of rules for which heater runs and when.

Questions

Heating Integration: Heat Pump, Gas & Solar Plumbing: common questions

Why does my heater keep tripping on low flow?+

A dirty filter, the wrong valve position, an undersized bypass or a pump running too slowly in that mode can all starve the heater. We measure the flow and fix the cause.

Can I add a heat pump to my existing gas heater?+

Usually, yes. Each needs its own flow range, the order matters, and the controls need to agree on which one runs.

Does solar need its own pump?+

Often. Roof collectors add static head that a filtration pump at low speed may not overcome. A dedicated solar pump is common, but it depends on the roof height and layout.

Where should a heat pump go?+

Somewhere with free airflow, a level, drained base and room to service it, away from neighbours' bedrooms. Night-time noise limits apply in Victoria.

Enquiries and quotes

Talk to us about your plumbing

Send a few wide photos of the plant and a short description of what the pool needs to do. We'll come back with the right first step.

Monday-Friday 9:30am-4:30pm, Saturday 9:30am-3:30pm. Sunday closed.

A phone number or an email address is enough.