A bigger pump is not always better. We size it to your pipes and set the right speeds so the pool runs properly without wasting power.
What we do
Installation of single and variable speed pool pumps
Before we arrive
Send photos of the old pump, the filter label, and the pipes.
Replacing a dead or leaking pump
Upgrading to save power
The old pump is too noisy
The pump is too weak for the heater
The old pump is too big and wastes power
Moving the pump to a new spot
Water flow needed for the pool
Pipe size and how many bends there are
Maximum pressure the filter can take
Flow needed for the heater and cleaner
Space, air, and power at the pad
Timers and control systems
Pool equipment we work on
We check the equipment, water path and controls before we recommend a repair.
Common problems
The same problem can have a few different causes. We test before we start replacing gear.
What might cause it
A suction leak, restricted pipe, incorrect valve position, unsuitable pump selection or commissioning speed may be limiting performance
How we check
We prime from each suction line, measure vacuum and pressure, and commission the pump across the speeds the pool equipment will use
What might cause it
The selected speed may be causing cavitation or excessive velocity, or the base and pipe supports may be transferring vibration
How we check
We run the pump through its speed range while monitoring prime, vacuum, flow and vibration, then correct the hydraulic or mounting issue
What might cause it
The programmed speed may fall below the connected equipment's minimum flow, or a filter or bypass restriction may be reducing the available margin
How we check
We find the lowest stable speed for each connected device, verify it with the system clean and program dedicated filtration and heating cycles
Our process
We check what the filter, heater, and cleaner need.
We look at the pipes, space, and power plug.
We fit the pump straight and make sure the pipes do not pull on it.
We program the right speeds for filtering, heating, and cleaning.
After the visit
We fit the right pump and get the water moving.
We fix any bad valves or air leaks while we are there.
We set the variable speeds to avoid wasting power.
Questions
Straight answers to the questions we hear most often.
It depends on the pipes and the filter. A pump that is too big will waste power and break the filter.
No. It makes more noise, uses more power, and can damage your other gear.
Yes, if the pump suits the pool. We need to make sure it runs fast enough when the heater is on.
Yes, we remove the old pump and all the rubbish.
We test the flow. We set a low speed for filtering, and a higher speed for the heater and cleaner.
Book pool pump installation melbourne
Send us your address, a few photos, and a quick description. We will come prepared with a clear idea of where to start.
Shop 13A, 328 Johnston Street, Abbotsford VIC 3067
9am to 6pm, Monday to Friday. Saturday by appointment.
Check service areas