Older concrete shells
A new interior may still leave older underground pipes in place. We gather evidence before assigning water loss to the shell or plumbing.
Ivanhoe pool and equipment service
Ivanhoe contains established homes on varied ground between the Darebin Creek and Yarra corridors. Many pool sites have mature landscaping, older concrete shells or equipment positioned on a different level from the water. Renovations can leave a modern plant connected to older buried hydraulics.






Local pool context
Ivanhoe pools often need the full system checked. Sloping blocks can mean long suction lines or equipment well below the water level. A new pump may still be connected to old underground pipework, so we diagnose what is actually on site.
A new interior may still leave older underground pipes in place. We gather evidence before assigning water loss to the shell or plumbing.
If the pump is sitting way below the pool, the static pressure changes how we isolate the water and drain the lines safely.
Custom screens can look good but may restrict ventilation and make tool access difficult.
Relevant work in Ivanhoe
We do not diagnose a fault from the suburb or symptom alone. Palatial Pools tests the pool, connected equipment and conditions we can measure.
We test the pump, filter, chlorinator, and heater as one complete system, rather than guessing.
We rule out evaporation and backwash loss before we charge you for a full pressure test.
We check the flow, the cover, and the airflow before we tell you the heater is dead.
We select equipment to suit your existing pipes, available power and how you use the pool.
Site access
If the equipment is down stairs, under a terrace or well away from the street, let us know. It affects safe carrying and where wastewater can be discharged.
Fault reasoning
| Observed symptom | Possible explanations | What confirms it |
|---|---|---|
| Pump basket drains after shutdown | Air leak, non-return valve issue, equipment elevation or valve sealing | Observe static loss and test the suction-side fittings |
| Older pool loses water | Evaporation, backwash use, fitting, pipe or shell defect | Record level change with the system on and off before targeted testing |
| Heater locks out intermittently | Low flow, bypass setting, control demand, ventilation or heater fault | Test flow and controls while the fault is active |
Photos, videos and calculator results can improve the service brief. They cannot confirm live flow, pressure, electrical safety, gas condition, concealed plumbing or structural leakage remotely.
Route to the shop
Heidelberg Road provides the main south-west connection through Fairfield and Clifton Hill to Johnston Street. Properties near Lower Heidelberg Road may use the Yarra-side approach before joining Heidelberg Road.
School traffic, Upper Heidelberg Road activity and congestion toward the Chandler Highway can extend the trip. The range is not an attendance guarantee.
Plan a shop visitBring for water testing
Use a clean container. Take the sample from below the surface, away from a return jet. Bring the pool volume, recent treatment, equipment status and the issue you are trying to solve.
Questions from Ivanhoe
No. The shell, hydraulics and each component should be assessed separately. Staged work may be appropriate.
No. A bill may show increased use, but topping up, irrigation and household demand can also change. Pool loss needs controlled measurement.
Yes. Valve condition and static pressure must be considered before equipment is opened or removed.
Yes. Use a clean container and bring a fresh sample during retail hours with recent treatment details.
Nearby service areas
Palatial Pools
Tell us the symptom, send photos of the gear, and let us know about any access issues.